I couldn’t hit the clubs at all. Can you use a little pipe cutter to cut graphite? Steel shafts do not need to be replaced. Chances are you don’t meet all the above criteria, so it’s probably not necessary to reshaft your clubs. Don’t forget your time and possible screw ups. Driver Razr Fit Xtreme Udesign 9. Lastly, you can put the new ferrules onto the shafts.
|Date Added:||10 October 2009|
|File Size:||17.71 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Posted June 22, S That will have a bearing on what shafts you can replace your old ones with without effecting the swing weight too much.
If you are coming from the inside on your swing then you might look at drivers that have less of a closed face angle or weakening your grip slightly which will make your club face a bit more open at impact. If you’re slicing the heck out of a stiff reshft, test a few Regular shafts in a shop before getting this one re-shafted.
Best thing to do is go to a TM club fitter.
Is it easy to reshaft iron set by myself?
I left there and went to 2nd Swing to look at hybrids and while I was hitting one I noticed the exact same club I was using with the stiff NV shaft in it just sitting against the wall in one of the hitting bays. Steel shafts do not need to be replaced. How much does reshafting golf clubs cost? How much would you say it costs to have new shafts fitted by a pro, going with a decent but not stupidly expensive make? Are Forgan golf clubs any good? In TMs case you would have to go with the TPs which have a more neutral face angle.
What is the difference between tour and regular golf clubs, i. Hawk, you said ‘usually’ you need a shaft puller for graphite. Pro Tourn Ed.
uou It also increase flex Remember me This is not recommended for shared computers. If it’s going to cost a fortune, then I’d rather save up for a new set entirely. I just purchased a Burner TP 9.
Get yourself a cheap shaft clamp, could be rubber, to hold the club in a vise. What is club golf? This is unless you are compensating for it with your hands and timing and that might cause a hook. We appreciate that you found this thread instead of starting a new one, but if you plan to post here please make sure it’s still relevant.
Want to hide this ad?
Will your grips be the correct size when you are done? I went to Golfsmith and looked into reshafting. Yes, you can do it yourself.
For all intents and purposes, these are the exact same shaft. For a new driver like that i would absolutely re-shaft it.
How To: The Poor Man’s Guide to Reshafting Irons
Slowly turn the extractor’s threaded bolt with a box wrench. Yeah, wearing hats indoors bothers me much more than not taking it off to shake.
I did this around 2 years ago with a set of Callaway irons I had- they were graphite and I changed 3-PW to steel. By bigoakJuly 24, in Golf Talk. Face angle controls lateral ball movement, shaft flex control horizontal ball flight.
GolfWRX – the world’s largest and best online golf community. By saevel25Wednesday at